Siemens SIMATIC IPC1047 Operating Instructions Manual page 24

Safety Instructions
2.1 General safety instructions
Electric shock and fire hazard due to damaged device
A damaged device can be under hazardous voltage and trigger a fire in the machine or
plant. A damaged device has unpredictable properties and states.
Death or serious injury could occur.
• Avoid installing and commissioning a damaged device.
• Label the damaged device and keep it locked away. Send off the device for immediate
Damage from condensation
NOTICE
Damage from condensation
If the device is subjected to low temperatures or extreme fluctuations in temperature during
transportation, moisture could occur on or inside the HMI device (condensation).
Moisture can cause a short-circuit in electrical circuits and damage the device.
• Store the device in a dry place.
• Bring the device to room temperature before starting it up.
• Do not expose the device to direct heat radiation from a heating device.
• If condensation develops, wait approximately 12 hours or until the device is completely
Fire protection enclosure
Note
The device meets the requirements for fire protection enclosures in accordance with
IEC/EN/UL 61010-2-201. It can therefore be installed without an additional fire protection
cover.
24
WARNING
repair.
dry before switching it on.
Operating Instructions, 07/2019, A5E45118479-AB
SIMATIC IPC1047