Raid1 System - Siemens SIMATIC IPC1047 Operating Instructions Manual

The installed RAID controller for the "Adaptec RAID ASR8405" module is displayed as
follows in the BIOS:
Additional software and documentation
Refer to the following software documentation from the manufacturer:
● Adaptec RAID Controller Quick Start Guide
The PDF file describes how you install the RAID controller and create a bootable RAID1
or RAID5 array. It also describes how you install the operating system and the controller
driver on the array.
● Adaptec RAID Controller Installation and User Manual
The PDF file contains comprehensive information on installation and configuration of the
RAID adapter card and the connected devices.
● Adaptec maxView Storage Manager User Manual
The PDF file contains comprehensive information on installation and use of Adaptec
maxView Storage Manager.
● Command Line Utility User Guide
The PDF file contains the user manual for the command line utility program and
comprehensive information on the use of ARCCONF.
In order to use the software, the operating system must be password-protected. The
password must be assigned before the software is installed. In a correct installation, the
operating system password and RAID software password are the same.
5.2.2.4

RAID1 system

The system can be configured as RAID1 (data mirroring on two hard disk drives). This
means that if there is a defective hard disk or there are cable problems, the system can
continue to operate in one channel and achieve a high degree of availability. You can find
additional information in chapter "Manage onboard RAID system (Page 46)".
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
Operating the device
5.2 Drive configurations
45