Mitsubishi Electric AE-200A Instruction Book page 83

5-2-10. Floor Layout
The floor layout on the [Floor] display under the [Monitor/Operation] menu can be changed, and the display position
of the groups on the floor can be changed.
Touch [Initial Settings] in the menu bar, and then touch [Floor Layout]. All unit groups that are under the control of
both AE-200 and AE-50 can be displayed on the Floor Layout screen of the AE-200.
Note: Some settings may not be accessible if logged in as a building manager.
Note: Up to 30 groups can be assigned to each area.
Important
● Although the Floor Layout settings can also be made on the AE-50's LCD, only the unit groups that are under the control of
AE-50 controllers can be set on the AE-50's LCD.
Floor selection
Area selection
Unassigned groups
Touch to display the groups
that have not been assigned
to an area.
Basic floor settings
Cut
Paste
[1] Basic floor settings
(1) Touch the "Basic floor settings" button to display the
basic floor settings screen.
(2) Touch
to set the total number of floors, and select
the floor layout to be used.
Note: If the total number of floors is set to "--," none of the
floor layouts can be selected.
Note: Up to ten floors can be registerted.
WT07190X01
83
Save Settings
Touch to save the changes
made.