Mitsubishi Electric AE-200A Instruction Book page 62

(5) Make the following settings, as required.
● Interlock settings (See section 5-2-8 "Interlocked LOSSNAY".)
● Block settings (See section 5-2-9 "Blocks".)
● Floor layout settings (See section 5-2-10 "Floor Layout".)
(6) Measurement settings must be made to use temperature
sensors, humidity sensors, and metering devices.
Touch [Function1] in the menu bar, and then touch
[Measurement].
Referring to section 5-3-1, make measurement settings, and
then touch [Save Settings].
(7) Touch the right triangle button to display the [Network] tab, and
touch it.
Referring to section 5-2-6, make necessary settings, and then
touch [Save Settings].
Note: When the LAN settings are changed, AE-200 will reboot, and
the step (8) below will be skipped.
(8) Touch [
] at the right top of the screen to move to the
[Monitor/Operation] screen.
Percentages of startup process completion will appear.
The initial settings are completed.
Note: When no communication errors occur, the startup process will
take about two or three minutes after the message appears.
When an error is occurring, it may take about five minutes.
WT07190X01
62