Mitsubishi Electric AE-200A Instruction Book page 75

[1] LAN Settings
LAN1 settings vary depending on whether the AE-200/AE-50 is connected to a dedicated LAN or an existing LAN.
See the sections below for how to set the AE-200/AE-50 IP addresses, subnet mask, and gateway addresses.
Although the settings for LAN1 and LAN2 will appear on the screen, only the settings for LAN1 is required. Before
making the settings, make sure that the LAN is connected to LAN1 port.
(1) LAN1 settings for connecting the AE-200/AE-50 to a dedicated LAN
Settings for an AE-200
Note: See the procedures below when making LAN1 settings on the AE-50.
(1) Make sure that [AE200] is selected in the [Controller] section.
(2) Enter the AE-200's IP address in the [IP Address] field. If the LAN has been newly set up, allocate IP
addresses to the AE-200 units in a sequential order starting with [192.168.1.1]. For example, the first
AE-200 unit will have an IP address of [192.168.1.1], the second AE-200 unit will have an IP address of
[192.168.1.2] and so on. (The same IP addresses cannot be used.)
Allocate IP addresses to the AE-50 units in a sequential order starting with [192.168.1.211].
Note: The recommended IP address ranges are as follows.
AE-200: Between [192.168.1.1] and [192.168.1.40]
AE-50: Between [192.168.1.211] and [192.168.1.249]
PC: Between [192.168.1.101] and [192.168.1.150]
(3) Enter [255.255.255.0] in the [Subnet Mask] field (unless otherwise specified).
(4) When monitoring the system remotely or using e-mail function via a dial-up router, enter the router IP
address in the [Gateway] field.
Leave the [Gateway] field blank when not connecting a dial-up router.
[192.168.1.254] is recommended for use as the IP address of the dial-up router. Refer to the dial-up router
instruction manual for details of how to set the IP address.
Note: [192.168.1.254] is recommended for use as the IP address of the dial-up router. Refer to the dial-up router
instruction manual for details of how to set the IP address.
Note: The use of a dial-up router with no modem requires a modem (for analog or ISDN) to be connected between the
router and the public phone line.
Settings for when connecting one or more AE-50 controllers
(1) Select [AE1], [AE2], or [AE3] in the [Controller] section to make settings for each AE-50.
(2) Enter the IP address of the AE-50 that is connected to the AE-200 in the [Dstn IP address] field.
A message that indicates that the connection information of the AE-50 is being collected will appear for a
few minutes.
Note: AE-50 will not operate properly and the AE-50 software version will not appear if the entered address does not
match the ones that have been set on the AE-50.
WT07190X01
75