Software Update - Mitsubishi Electric AE-200A Instruction Book

6-3. Software Update

The software can be updated by reading the update file in the USB memory device.
Touch [Maintenance] in the menu bar, and then touch [Update].
Note: The update is required on each AE-200/AE-50.
Important
● The USB memory device may not be recognized if you insert and remove it within a short time. If this happens, reset the
AE-200/AE-50.
(1) Remove the controller cover, and insert a USB memory device to the USB port.
(2) Touch [Software Update] to read the update file.
Note: The Status LED will blink in blue while the software is being updated. (Refer to section 2-5 "Controller interface" for
details about the LEDs.)
Note: Do not turn off the power to the AE-200/AE-50 while the software is being updated.
Note: The AE-200/AE-50 will reboot after the update is complete.
WT07190X01
104