Mitsubishi Electric AE-200A Instruction Book page 73

[3] Display Format
(1) In the [Occupancy] section, make the Show/Hide setting for the occupancy/vacancy status that is detected
by the built-in occupancy sensor on the ME remote controller (North America: PAR-U01MEDU, Europe: PAR-
U02MEDA).
Select [Hide] not to display the occupancy/vacancy status on the [Floor] or [Block] display.
Select [ ] (blue) to display the occupancy icon when the sensor on the remote controller detects occupancy.
Select [ ] (gray) to display the vacancy icon when the sensor on the remote controller detects vacancy.
Select [
the room.
Note: If the ME remote controller has no built-in occupancy sensor, the occupancy/vacancy icons will not be displayed on the
[Floor] or [Block] display.
(2) In the [Brightness Sensor] section, make the Show/Hide setting for the brightness/darkness status that is
detected by the built-in brightness sensor on the ME remote controller (North America: PAR-U01MEDU,
Europe: PAR-U02MEDA).
Select [Hide] not to display the brightness/darkness icons on the [Floor] or [Block] display.
Select [ ] (yellow) to display the brightness icon when the brightness level in the room reaches the
predetermined brightness level.
Select [ ] (gray) to display the darkness icon when the darkness level in the room reaches the
predetermined darkness level.
Select [
darkness level of the room.
Note: If the ME remote controller has no built-in brightness sensor, the brightness/darkness icons will not be displayed on the
[Floor] or [Block] display.
Note: The brightness/darkness detection thresholds are set on the ME remote controller (North America: PAR-U01MEDU,
Europe: PAR-U02MEDA)
(3) In the [Date] section, select the desired display format for year, month, and date.
(4) In the [Time] section, select the desired display of time format.
(5) In the [Temperature] section, select the desired temperature unit [ºC] or [ºF].
(6) In the [Language] section, select the desired display language.
(7) In the [Test run] section, select [Use] or [Do not use]. Select [Use] to perform a test run from the operation
settings screen.
(8) In the [Screen lock] section, select [Use] or [Do not use]. Select [Use] to activate the screen lock function. (Refer
to section 5-2-2 "Locking the screen" for details.)
(9) In the [Room temperature] section, select the desired temperature display option to be used on the [Floor] or
[Block] display.
Select [Always show] to display the temperature at all times, [Show during operation] to display the
temperature only during operation, and [Hide] not to display the temperature.
(10) In the [Pressure unit] section, select [MPa], [PSI], or [kgf/cm
(11) In the [Humidity] section, make the Show/Hide setting for the humidity reading of the built-in humidity sensor
on the ME remote controller (North America: PAR-U01MEDU, Europe: PAR-U02MEDA).
Select [ON] to display the humidity reading on the [Floor] or [Block] display.
WT07190X01
] (blue/gray) to display the occupancy or vacancy icon according to the occupancy status of
] (yellow/gray) to display the brightness or darkness icon according to the brightness/
].
2
73