Mitsubishi Electric AE-200A Instruction Book page 16

[3] [Measurement] display
Touch [Monitor/Operation] in the menu bar, and then touch [Measurement].
The measurement data of the temperature sensors, humidity sensors, and metering devices will appear.
Note: Measurement settings on the [Measurement] screen under the [Function1] menu are required to display the measurement
data on this screen.
Note: An AI controller (PAC-YG63MCA), a commercially available temperature sensor, and a humidity sensor are required to
measure the temperature and humidity.
Note: A PI controller (PAC-YG60MCA) and a commercially available pulse-output metering devices are required to measure the
electric, water, heat, and gas consumptions.
Note: The [Controller] setting will appear when the [System Exp] setting on the [Unit Info.] screen is set to [Expand]. Switch the
[Controller] setting between [AE200], [AE1], [AE2], and [AE3] to display the data for each AE-200 and AE-50 individually.
Controller
Select [AE200] to display
the data for AE-200, and
select [AE1], [AE2], or [AE3]
to display the data for each
AE-50.
Measurement item
Measurement value
Item
Measurement value
WT07190X01
The current measurement values will appear.
Note: The following icons are used to indicate the measuring devices. Icons will appear in
orange when the measurement value reaches the upper or lower alarm threshold value
that has been set on the [Measurement] screen.
Temperature sensor
Humidity sensor
Metering device
*1 When there is a communication error, the measurement value of the temperature or
humidity sensor will be "--."
*2 When there is a communication error, the measurement value of the metering device will be
the measured value immediately before the error detection.
Description
Upper/lower alarm
Normal threshold value is
reached.
16
Communication
error
*1
*1
*2