Mitsubishi Electric AE-200A Instruction Book page 74

5-2-6. Network
Touch [Initial Settings] in the menu bar, and then touch [Network].
Make necessary basic system settings such as LAN settings, M-NET settings, and external input settings for each
AE-200 and AE-50, and then touch [Save Settings]. A message will appear asking whether or not to restart the
controller. Touch [OK] to restart the controller to reflect the changes.
Note: The Network settings may not be accessible if logged in as a building manager.
Note: The [Controller] setting will appear when the [System Exp] setting on the [Unit Info.] screen is set to [Expand]. Switch the
[Controller] setting between [AE200], [AE1], [AE2], and [AE3] to make settings for each AE-200 and AE-50 individually.
Important
● Network settings for the AE-50 must be made with the AE-50 properly connected to ensure proper settings. Those settings
made without the connection of AE-50 will not be reflected.
1st page
Controller
Select [AE200] to make
settings for AE-200, and
select [AE1], [AE2], or [AE3]
to make settings for each
AE-50.
LAN Settings
Set the IP address, subnet
mask, and gateway address.
Touch to go to the next
page.
2nd page
Touch to go to the previous
page.
WT07190X01
74
M-NET Settings
Set the M-NET address
and range of prohibited
controllers.
External Input Setting
Set the external signal input
mode.
Save Settings
Touch to save the changes
made.