If You Have A Previously Configured Boot Diskette - Black Box LRA001A-R2 User Manual

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER USER'S MANUAL

4.1 If you have a previously configured boot diskette...

Figure 4-2. If you have a previously configured boot diskette...
If the Router boot diskette has not been previously configured, proceed to Section 4.2.
If your network administrator has prepared a previously configured boot diskette for you, simply
insert the diskette into the Router's diskette drive and start the unit. The Router starts and uploads
its configuration parameters from the boot diskette. Your Router is now fully operational. Do not
perform the instructions in Chapters 4 and 5, and proceed directly to Chapter 6 to test your installation.
Store the backup boot diskette for the Router in a secure place. The backup boot diskette also contains
your Router's configuration, as configured by your network administrator.
If you are the network administrator, you can preconfigure boot diskettes for the remote
Router sites in advance, test them, and then mail them to the remote sites. This may be
the easiest method to install and configure Routers. Make sure that you also create a
backup boot diskette.
26
Ethernet Hub
10BASE-T, AUI
NOTE
Router
Previously configured
boot diskette