Tip; Trace - Black Box LRA001A-R2 User Manual

2.22 tip

Establishes a connection with an interface
Syntax
tip iface
Description
Using a terminal program, the tip command establishes a full-duplex terminal connection to a modem
interface. It is a diagnostic tool used to manually send commands to a modem. Normally this command
is only used to test new modem configuration options.
The tip command is only used on modem interfaces. Do not use tip on a modem that
has a dialer running.
Before using tip on a modem line, the line dialer must be stopped with the dialup iface inactive
command.
Subcommands and parameters
tip iface
Establish a full duplex connection to a modem interface.
iface modem0-4

2.23 trace

Send packet-type status (for an interface) to the console.
Syntax
trace iface [in | out | hex | ppp | packet | up | > filename]
Description
The trace command enables packet tracing on a given interface (iface) to standard output. The default is
to display input and output packet headers. Packet headers are fully decoded up through the transport
level. Packet data is displayed as ASCII characters and periods representing unprintable characters.
If you are logged in on an interface, you are not allowed to trace that interface.
ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
NOTE
NOTE
183