Black Box LRA001A-R2 User Manual page 231

to IP hosts in the community ACL.
snmp delete community community_name
Delete the community from the access control database. When a community is removed, its
community_name is invalidated as well as its access control list and access privileges.
community_name
snmp set acl community_name host_addr [host_addr...]
Use this subcommand to add IP addresses to the community ACL. The community must exist before
issuing this command. Before host names have been added to the empty ACL any host is allowed access
to Router SNMP MIB objects. Once a host is assigned to an ACL, only that host may gain access. IP
addresses are specified in dotted-quad notation, or by name if a Domain Name Service is in use.
snmp delete acl community_name host_addr [host_addr...]
Remove host(s) from the Access Control List of a community.
community_name host_addr
host_addr
snmp set authtrap {on | off}
Enable and disable transmission of SNMP authenticationFailure traps.
on—Enables transmission. When enabled, if an incoming SNMP PDU has insufficient access control
privileges based on community name and source address, then authenticationFailure traps are sent to
all IP addresses in the ACLs of communities configured to receive traps.
off—Disables transmission.
snmp set contact contact_string
Set the name of the person responsible for the node.
contact_string.
snmp set location location_string
Set the system location.
location_string.
snmp status [-c [community_name]]
Use this subcommand to display the current status of SNMP. The default display with no command-line
parameters includes:
• indication that SNMP is enabled or disabled
• indication that SNMP Authentication Trap transmission is enabled or disabled
• SNMP system variables including sysDescr, sysLocation, sysContact, sysName, and sysUptime
-c—parameter is used to display the contents of the access control database. The community data for
all communities is displayed unless the community_name is specified on the command line. In this
case, the information for the specified community is displayed.
ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
Enter the name of the community.
Enter the address(es) of the host to remove.
Enter additional addresses if necessary.
Enter the name. The default is "Technical Support."
The default location is "Computer Room."
231