Avaya IX Room Systems XT Series Release Notes page 31

© 2019 Avaya Inc. All rights reserved
Presence
Remote Control
Web
Collaboration
(WCS)
MSSv1
Release Notes for Avaya XT Series
SNMP default community
RVXT5000-1243
names are easily guessable
RVXT5000-1244 SNMPv1 is not secure
Manual Presence Status is
forced to "Busy" when in a SIP
call when using IP Office as
Presence and SIP Server.
Offline presence status in not
correctly displayed by XT when
using Aura Presence Server 7.1
(pre-release)
It is not possible to subscribe to
Avaya One-X
accounts used by One-X Portal
Portal for IP Office.
clients.
Contacts are not notified of
subscription requests. It is not
possible to grant/revoke
Avaya Aura
subscription request.
Presence Server
XT endpoint must manually
subscribe to other contacts to
view their presence
Remote Control Codes 97, 98,
99 cannot be used any longer to
control the Codec Unit.
FPS when sending or receiving
Web Collaboration on XT is low
WCS sharing is not active
When WCS Rx is active, there is
no gallery layout
When the received
collaboration resolution is
higher than 1920 width or 1080
height the presentation is
cropped on the monitor.
Web collaboration cannot be
enabled on systems with CPU
version lower than 2.0
XT cannot send and receive
presentation if the call is audio-
only
MSS cannot be enabled on
systems with CPU version lower
than 2.0
If Web Collaboration is disabled,
no presentation is available in
an MSS meeting
Only XT Sip participants or with
9.0 (or new Equinox clients
supporting MSSv1) can join an
MSSv1 meeting. H.323
participants or old XT or third-
party endpoints will join as
audio only.
Change default SNMP community names or disable
SNMP
SNMP is disabled by default to enhance security
Select "Aura 7.1" in XT presence server type
As a workaround you can temporarily assign the
same account to another XT, subscribe to it from
your XT, and then move it again to the client.
Only codes [1...96] can be used to control the codec.
Codes 97, 98 and 99 are reserved to control the
Deluxe Camera since release 8.3.6.
Reprogram your codec and your remote control to
use a different code.
Rx FPS depends on resolution and content of the
remote sharing.
TX FPS depends on resolution and content of local
sharing, but it is further reduced if using an analog
DVI input.
Check that Calls>Preferences>Dual Video> Web
Collaboration (WCS) is set to Yes
Check that your XT is managed in the meeting (you
should see Local – Your XT Name) listed in XT UI,
Participants tab if the call is H323 or the
Conferencing Management is 8.3.x.
Check that your XT has a valid DNS configured, as it
must resolve the WCS FQDN.
Check that your XT can connect to the WCS server
(WCS server info are available through XT's CS
Package)
This is by design. Gallery layout preference is
ignored when receiving WCS.
You can pan/tilt the received presentation using the
arrows when the presentation is displayed in a
major window (full screen or first pap or pop
window in any monitor). Change layout to pan the
near camera in place of the presentation.
Known Issues | 31