2.1 GENERATOR SET INSTALLATION AND REMOVAL
CHASSIS
GENSET
SECTIONAL VIEW
The Genset centered under the trailer chassis is easily
removed with a fork lift truck (Fork lift pockets are
provided) capable of handling 2000 pounds.
NOTES
1. When installing genset, torque mounting
bolts to 85-90 ft-lbs (11.75-12.44 mkg).
2. It is not recommended using original
locknuts for second installation.
a. Installation:
1. Place forks into fork lift pockets of generator set.
Attach safety chain between unit and fork truck.
SECTION 2
OPERATION
MOUNTING CLIPS
CURBSIDE VIEW
MOUNTING CLIP
GENSET BRACKET
Figure 2-1. Generator Set Mounting
2-1
CHASSIS CENTER LINE
7
1.
Bolt (1/2-13 x 2-1/2 lg Grade 8)
2.
Flat Washer
3.
Mounting Clip
4.
Genset Mounting Bracket
5.
Rectangular Washer
6.
Locknut
7.
Chassis I-beam
2. Follow Figure 2-1 for installation of genset. Upon
completion, remove safety chain before removing forks
of fork lift truck from unit.
b. Removal:
1. Disconnect power cable to unit (if connected).
2. Disconnect fuel lines (if fuel tank is remote).
3. With fork lift in position and safety chain
attached remove hardware (see Figure 2-1) and then
remove genset.
EXPLODED VIEW
1
2
3
4
5
6