Dmx Controller - ACME Dotline360 TB-1230 QW User Manual

Tilt Offset—Tilt home position adjustment
Enter offset mode, Select Tilt, press the ENTER button to confirm, the present position will blink on the
display, use the UP/DOWN button to offset the value from -128 to 127, press the ENTER button to store.
Press the MENU button to exit.
Zoom1 Offset—Zoom1 home position adjustment
Enter offset mode, Select Zoom1, press the ENTER button to confirm, the present position will blink on
the display, use the UP/DOWN button to offset the value from -128 to 127, press the ENTER button to
store. Press the MENU button to exit.
Zoom2 Offset—Zoom2 home position adjustment
Enter offset mode, Select Zoom2, press the ENTER button to confirm, the present position will blink on
the display, use the UP/DOWN button to offset the value from -128 to 127, press the ENTER button to
store. Press the MENU button to exit.

4.DMX Controller

Use universal DMX controller to control the units, you have to set DMX address from 1 to 512 channels so
that the units can receive DMX signal.
Press the MENU button, then select the DMX Settings button and the will blink on the
Channel Mode
display. Use the DOWN/UP button to change the DMX512 address. Once the address has been selected,
press and keep ENTER button pressed up to when the display stops blinking or storing automatically one
minute later. To go back to the functions without any change press the MENU button again.
If you use please refer to the following diagram to address your DMX512 channel for the first 4 units.
14B