Troubleshooting; Disposal - LOGICDATA DYNAMIC MOTION System Manual

11 TROUBLESHOOTING

Problem
The Actuator does not
work
The table only moves
downwards
The User Interface does
not work
For further information, or if you are experiencing problems that are not covered in this chapter, refer to the
Operating Manual of each individual product in the DM System.

12 DISPOSAL

All products in the DM System are subject to the WEEE Directive 2012/19/EU.
• Dispose of all components separately from household waste. Use designated collection
points or disposal companies authorized for this purpose
DYNAMIC MOTION SYSTEM - SYSTEM MANUAL // PAGE 26
Possible cause Solution
The system is not Ensure that the system has been connected to the
plugged in Power Unit correctly
The Actuator is not Ensure that the Actuator is properly connected to
connected properly all components of the system
Poor plug connection Ensure that all plugs have been connected prop-
erly
The Actuator is defec- Replace the Actuator. Contact LOGICDATA if the
tive problem persists
The User Interface is
Replace the User Interface. Contact LOGICDATA if
defective
the problem persists
There was power failure
while the table was in
motion
Perform a Position Reset Procedure (see Chapter
The Power Unit was
4.7 Performing a Position Reset
disconnected while the
device was in motion
Reset required
The Actuator is defec- Replace the Actuator. Contact LOGICDATA if the
tive problem persists
The User Interface is Replace the User Interface. Contact LOGICDATA if
defective the problem persists
Procedure)