Page 1
User Manual Rev 2 – 08/2007 Availability and specifications are subject to change without prior notice. LOGICDATA assumes no liability for maloperation or improper use of products. LOGICDATA will at point of delivery replace/repair defective products covered by the warranty.
Table of Contents Table of Contents ....................... 2 Installation and Starting up .................. 3 Operation......................4 Manual mode with Handset................4 Automatic mode ....................4 Memory mode ....................4 Up/Down mode..................... 5 Manufacturer information..................7 Seite 2 von 7...
The system is operating as soon as the red LED for „Power“ is turned on. Switch „HS/Off/Auto“ Power-LED For LOGICDATA CBX-motor controls an external supply (9VDC) has to be connected. Plug-in the handset into the 8-pin DIN socket „HS“. Seite 3 von 7...
Shift the switch “HS/Off/Auto” to “HS”. The green LED for “HS” is turned on. Switch „HS/Off/Auto“ Now all function of the LOGICDATA handsets can be carried out. 3 Automatic mode The automatic handset has two different automatic modes: 3.1 Memory mode With this function the desk will drive continously to the memory positions 1, 2, 3 and 4.
Shift the switch “Mem Up/Down” to “Mem”. The green LED for “Mem” is turned on. Shift the switch “HS/Off/Auto” to “Auto”. The green LED for “Auto” is turned on. Switch „Mem Up/Down“ Switch „HS/Off/Auto“ Knobs While driving to a memory position, one of the 4 yellow LEDs „M1, M2, M3 und M4“...
Page 6
Shift the switch “Mem Up/Down” to “Up/Down”. The green LED for “Up/Down” is turned on. Shift the switch “HS/Off/Auto” to “Auto”. The green LED for “Auto” is turned on. Switch „Mem Up/Down“ Switch „HS/Off/Auto“ Knobs While driving to the upper and lower desk position, the 4 yellow LEDs bs and bs are turned on.