Standard Functions; Adjusting The Table Top Height; Advanced Functions; Saving Memory Positions - LOGICDATA DYNAMIC MOTION System Manual

5.1

STANDARD FUNCTIONS

This section describes functions that can be performed using both Comfort and Basic User Handsets along-
side the DM System. If your DM System will be controlled by a different User Interface, consult that product's
Operating Manual for instructions and safety advice.
5.1.1

ADJUSTING THE TABLE TOP HEIGHT

CAUTION Risk of minor or moderate injury through crushing
Your fingers may be crushed when you attempt to change the height of the table
• Keep fingers away from moving parts
• Ensure that no persons or objects are in the table's range of motion
INFO
The Table Top will move up or down until the UP or DOWN Key is released, or if a pre-de-
fined stopping point has been reached.
To move the Table Top UP:
Press and hold the UP Key until the desired height has been reached
To move the Table Top DOWN:
Press and hold the DOWN Key until the desired height has been reached

5.2 ADVANCED FUNCTIONS

This section describes functions that can only be performed using Comfort User Handsets alongside the DM
System. If your DM System will be controlled by a different User Interface, consult that product's Operating
Manual for instructions and safety advice.
5.2.1 SAVING A MEMORY POSITION
This function saves a set Table Top position. One Memory Position can be saved per Memory Position Key.
1. Move the table to the desired height (Chapter 5.1.1, Adjusting the Table Top height)
▸ The display shows the Table Top height (e.g. 73 cm)
SAVE
2. Press the SAVE Key.
DYNAMIC MOTION SYSTEM - SYSTEM MANUAL // PAGE 19