Key Lock; Correcting The Height Display - LOGICDATA DYNAMIC MOTION System Manual

6.2.3 KEY LOCK

Activating the Key Lock prevents you from moving the table if you accidentally press a Key. The Key Lock can
be activated and deactivated by swiping across the bottom edge of the Handset. Alternatively, swipe horizon-
tally across the left or right-hand side of the Handset (figure 5, Activating the Key Lock). The display must be
active for you to activate the Key Lock. To activate an inactive display, press any Key.
Fig. 5: Activating the Key Lock
After you have activated the Key Lock, a key is displayed on the screen.
Fig. 6: Locked User Interface

6.2.4 CORRECTING THE HEIGHT DISPLAY

This feature changes the height displayed on the Handset. It does not affect the table's actual height.
Press the SAVE Key.
SAVE
The display shows S –.
Press and hold the DOWN Key for approximately 5 seconds.
The display starts to flash.
Use the UP Key or DOWN Key to set the new height
Press the SAVE Key.
SAVE
The height display is now set to the new Table Top height.
DYNAMIC MOTION SYSTEM - SYSTEM MANUAL // PAGE 23