Requirements For Assembly - LOGICDATA DYNAMIC MOTION System Manual

INFO
Your Table System must be controlled using a DYNAMIC MOTION-compatible
User Interface. A User Interface is a general term that covers Handsets (Basic and
Comfort) and other products that can control the System, e.g. LOGIClink. Assembly
and Operation differ depending on which type of User Interface will be installed.
Unless otherwise stated, the instructions in this Operating Manual assume that the
user has installed a Table System alongside a Comfort or Basic Handset. If you have
purchased a DM System for use alongside a different User Interface, you are obliged to
read the Operating Manual of your chosen User Interface in full.
4.1

REQUIREMENTS FOR ASSEMBLY

WARNING Moderate risk of death or serious injury through electric shocks
Connecting the system incorrectly can lead to death or serious injury through electric
shocks.
• Ensure that the supplied voltage complies with each product's type plate
• Ensure all components are connected to the correct sockets
• Disconnect the Power Unit before removing or connecting any components
• If a Power Hub is used, connect the system to the Mains only after all other com-
ponents (Actuators, User Interfaces, etc.) have been connected to the Power Hub
WARNING Moderate risk of death or serious injury through electric shocks
Using damaged products may lead to death or serious injury through electric shocks.
• Do not use the User Interface or Power Unit if you see the housing is damaged
CAUTION Risk of minor or moderate injury through improper handling
Improper handling of the system during assembly may lead to minor or moderate inju-
ry through cutting, pinching, and crushing.
• Read all instructions and safety notices carefully
NOTICE
Ensure proper ESD handling during assembly. Damage that can be attributed to electro-
static discharge will void warranty claims.
NOTICE
Before assembly, all parts must be acclimatised to the ambient conditions.
NOTICE
Operating the table system when it is not properly connected can damage the product.
• Ensure all Cables are properly connected
• Ensure that all required Actuators are ready to be operated
• Do not operate the DM System until it is properly connected
Perform a product risk assessment so that you can respond to potential residual haz-
INFO
ards. Assembly instructions must be included in your end user Operating Manual
Before assembling the table system, ensure the following requirements are met:
• All Actuators have been mounted properly into the Height-Adjustable Columns
• The Height-Adjustable Columns have been mounted correctly onto the Table Top
• The DM System will be connected at a voltage compliant with the Type Plate
• There is no load voltage on any parts
DYNAMIC MOTION SYSTEM - SYSTEM MANUAL // PAGE 11