Section 3 - Servicing And Conversion - Falcon G2102 C Installation And Servicing Instructions

SECTION 3 - SERVICING and CONVERSION

Important
BEFORE ATTEMPTING ANY SERVICING ENSURE THAT THE ISOLATING COCK AND MAIN
ELECTRICAL SUPPLY ARE TURNED OFF AND THAT IT CANNOT BE INADVERTENTLY TURNED
BACK ON.
Note
WHEN REPLACING CONNECTIONS, REFER TO WIRING DIAGRAM IN THIS MANUAL. ALL WIRES
ARE NUMBERED.
AFTER ANY MAINTENANCE TASK, CHECK THE APPLIANCE TO ENSURE THAT IT PERFORMS
CORRECTLY AND CARRY OUT ANY NECESSARY ADJUSTMENTS AS DETAILED IN SECTION 1.
After carrying out any servicing or exchange of gas carrying components -
ALWAYS CHECK FOR GAS SOUNDNESS!
THESE APPLIANCES MUST ONLY BE CONVERTED FOR USE WITH OTHER GASES BY A QUALIFIED
ENGINEER.
3.1 GAS CONVERSION CHECK LIST
For conversion to NATURAL GAS, add correct external governor for G2102 C hob and set the
burner pressure on Open Top Gas Tap manifold. Refer to Section 2.5.1.
For conversion to PROPANE GAS, remove external governor from G2102 C hob gas circuit.
Other considerations -
CHANGE INJECTORS (Refer to Section 1.8)
CHANGE OPEN TOP GAS TAP LOW POSITION SCREWS (Refer to Section 1.10)
ADJUST GOVERNOR PRESSURE – NATURAL GAS MODELS ONLY (Refer to Section 2.5.2).
ATTACH GOVERNOR OVERRIDE SCREW – PROPANE MODELS ONLY.
CHANGE DATA PLATE
3.2 REMOVAL OF PANELS and COMPONENTS
3.2.1 Oven Control Panel
Access to various electrical controls, terminals etc, also piezo igniter, is gained upon withdrawal of
oven control panel. Remove fixings which secure panel and draw it forward.
3.2.2 Removal of Hob Control Panel (G2102 C only)
Remove control knobs.
Open oven doors and undo fixings along top and underside of facia.
Pull control panel forward to remove.
Replace in reverse order.
3.2.3 Removal of Hob (G2102 C only)
Remove hob pan supports, burner heads and aluminium bezels.
The hob is retained by four ball-stud fixings. Pull hob upward to access open top burner
venturi/injector holders.
Replace parts in reverse order.
Ensure burner head locates correctly upon burner bezel. This is achieved when the pips and
notches of the parts align to prevent burner head from rotating. Refer to Section 4 of User
Instructions.