Table of Contents
Advertisement
22. Adjusting the tilt of Inner cover
22-1. Verify the tilt of Inner cover 6 .
22-1-1. Verify that the tilt of Inner cover 6 , due to Frame A 9 , is parallel with the Case 1 .
22-1-2. If you can find the tilt as shown, adjust it by pushing the portion of the arrow down.
22-1-3. Make sure to push down the large area as possible so that the pressure will be applied equally to the surface.
Press down
1
Case
23. Installing Clear dome
23-1. Install Clear dome 28 to Main unit.
23-1-1. Align the nails of Clear dome 28 with the groove of Main unit, then push it down as possible.
23-1-2. Turn Clear dome 28 clockwise 13 degree to set.
Note1: Make sure not to touch Clear dome 28 directly.
Note2: If you find any dirt on Clear dome 28 , wipe it with soft cloth moistened cleaning solution (not including alcohol)
gently.
When in the transport or storing:
1. Set Buffer B 257 into Clear dome 28 .
2. Protect Clear dome 28 with polyethylene sheet.
Inner cover has been tilted.
Figure of Step 22-1
Main unit
28
Clear dome
Figure of Step 23-1
Adjust
1
2
–46–
Right adjustment
257
Buffer B
Advertisement
Table of Contents
