Installing Sy-1 Board Ass'y (Compl Pwb Sy-1) - Sanyo VCC-9300 Mechanism Service Technical Information

17. Installing SY-1 board ass'y (Compl pwb SY-1)

17-1. Install Relay/I-O cable ass'y 159 to SY-1 board ass'y (Compl pwb SY-1) 202 , then tighten Screws 112 (x2) using
Washers 114 (x2) and Nuts 113 (x2).
Torque: 75.6 cN•m (7.7 kgf•cm)
Note1: Apply Screw lock after tightening.
Note2: Make sure to install Relay/I-O cable ass'y 159 with tottering.
202
SY-1 board ass'y
(Compl pwb SY-1)
159
17-2. Install the connector of Relay/I-O cable ass'y 159 to CN204.
Relay/ I-O cable ass'y
114
113
CN204
Connector of Relay/ I-O cable ass'y 159
112
Screws
3x12 mm (x2)
114
Washer (x2)
309
Screw lock (x2)
*Note1
113
Nut 5.5 mm (x2)
Figure of Step 17-1
Figure of Step 17-2
–42–