Table of Contents
Advertisement
10. Installing Camera unit
10-1. Pass 11P connector of Camera cable 155 through the tilt hole of the unit reassembled in Step 8-3.
10-2. Then install the 11P connector to I-F board ass'y 204 of the unit in Step 9-9.
10-3. Install the unit reassembled in Step 9-9 to the unit in Step 10-2, then tighten Screws 102 (x4).
Torque: 43.2 cN•m (4.4 kgf•cm)
Note1: Make sure to install without Camera cable 155 caught in.
Figure of Step 10-1
10-4. Install Camera cover 5 to the unit reassembled in Step 10-3, then tighten Scews 103 (x4).
Torque: 43.2 cN•m (4.4 kgf•cm)
Apply Screw lock after tightening screws.
Note1: Make sure to install Camera cover 5 without catching Flexible flat cable 65 .
5
308
Screw lock
(x4)
103
Screws
2.6x3 mm
(x4)
103
155
Camera cable
204
The unit reassembled
in Step 8-3
102
The unit reassembled
in Step 10-3
Camera cover
The unit reassembled
in Step 10-2
155
Camera cable
I-F board ass'y
102
Screws
2.6x4 mm
(x4)
Figure of Step 10-4
–31–
The unit reassembled
in Step 9-9
Figure of Steps 10-2 and 10-3
65
Flexible flat cable
Advertisement
Table of Contents
