Table of Contents
Advertisement
14-5. Apply some Oil compound 307 to the specified position of Case 1 .
14-6. Install the unit reassembled in Step 13-1 to Case 1 , then tighten Screws 101 (x4).
Torque: 75.6 cN•m (7.7 kgf•cm)
Apply screw lock after tightening screws.
Note1: Making sure of the direction to install Case 1 while referring the figure of Note1.
307
Oil compound
*Apply some Oil compound.
Figure of Step 14-1
Alignment hole
The unit reassembled
in Step 13-1
Alignment pin
Figure of Note1
Note2: Make sure of the clealance
between Pan sensor and
Magnet.
101
Screws
3x10 mm (x4)
1
Case
Figure of Step 14-2
Clearance between Pan sensor and Magnet
–36–
308
Screw lock
(x2)
101
Clearlance
Advertisement
Table of Contents
