Table of Contents
Advertisement
9-5.
Install Magnet 59 to Magnet base 8 making sure of the direction, then apply some instant glue into the space to fix.
8
Magnet base
9-6.
Install the unit reassembled in Step 9-5 to the unit in Step 9-4 as shown, then tighten Screw 103 (x1).
Torque: 43.2 cN•m (4.4 kgf•cm)
Apply Screw lock after tightening screws.
Install Flexible flat cable 65 to the connectors on the unit reassembled in Step 9-4 and I-F board ass'y 204 .
9-7.
Note1: Make sure of the direction of the terminals when installing.
103
Screw
2.6x3 mm
(x1)
The unit
reassembled
in Step 9-5
Figure of Step 9-6
9-8.
Install I-F board ass'y 204 to the left of Camera support 12 , then tighten Screws 104 (x2).
Torque: 21.2 cN•m (2.1 kgf•cm)
Note1: Put the excess of Flexible flat cable 65 under I-F board ass'y 204 .
Install the connector from Fan motor ass'y 153 to I-F board ass'y 204 .
9-9.
104
Screws
2x4 mm
(x2)
12
Camera support
64
Camera
59
Magnet
(Fix using some instant glue.)
(View from the front to install)
Figure of Step 14-1
308
Screw lock (x1)
The connector from
Fan motor ass'y
153
Figure of Steps 9-8 and 9-9
–30–
*Make sure of the position of the mark
1
Figure of Step 9-7
204
I-F board ass'y
65
Flexible
flat cable
2
204
I-F board ass'y
Advertisement
Table of Contents
