Table of Contents
Advertisement
11. Removing Bearing Tilt mechanism part
11-1. Remove Camera cable 155 while bending the connector on the camera side 90 degree.
This is the disassembling procedure after the disassembling of:
1. Removing Base unit: Page 9
2. Removing Rotation unit: Page 9
3. Removing Main board ass'y: Page 10
5. Removing Camera unit and Fan motor ass'y: Page 12
6. Removing Slip ring ass'y (Step 6-1): Page 13
11-2. Remove Lock nut 52 using Guide wrench B 302 , then remove T-Holder unit.
11-3. Remove Ritina 22 on T-Holder unit using Guide wrench A 301 , then remove Bearing 53 (x2).
Guide wrench A: VHJ-0151
Guide wrench B: VHJ-0152
Refer to Page 22 through Page 23, Step 5-2 through Step 5-4 on page 26, Step 6-1 on Page 27 and page 31
through page 34 for reassembling.
Figure of Step 11-1
302
Guide wrench B
(VHJ-0152)
52
Lock nut
24
Space collar
T-Holder unit
301
Guide wrench A
(VHJ-0151)
23
T-Shaft
22
Ritina
Figure of Steps 11-2 and 11-3
–18–
155
Camera cable
4
T-Holder
53
Bearing
17
Shim
Advertisement
Table of Contents
