Can Testing - Embest SBC8600B User Manual

Embest Technology Co., Ltd

root@arm:~# ifconfig eth1 192.168.168.116

root@arm:~# ifconfig
The information in HyperTerminal window is shown below;
eth1 Link encap:Ethernet HWaddr 00:17:EA:96:34:D5
Mask:255.255.255.0
Lo
4） Execute the following instruction to test the network communication

root@arm:~# ping 192.168.168.121
The information in HyperTerminal window is shown below;
PING 192.192.192.170 (192.192.192.170): 56 data bytes
64 bytes from 192.192.192.170: seq=0 ttl=128 time=4.486 ms
64 bytes from 192.192.192.170: seq=1 ttl=128 time=0.336 ms
The above information indicates the network is working properly.

3.11.12 CAN Testing

SBC8600B can be working as a CAN device. Please connect the CAN interfaces on
your SBC8600B and another CAN device according to the board schematic and the figure
shown below:
Copyright © 2017 Embest Technology
net addr:192.168.168.116 Bcast:192.168.168.255
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
SBC8600B-UM-V2.0
76