Display Mode Configurations Abs - Embest SBC8600B User Manual

Embest Technology Co., Ltd
The system image has a default setting for 4.3-inch LCD. You can change the
settings in UBOOT according to the detailed instructions contained in 3.10 Selecting
Display Mode.

3.10 Display Mode Configurations ABS

System supports a wide range of display mode (4.3/7.0-inch-LCD supported,
VGA/LVDS/9.7-inch-LCD not supported). Users can change the display mode by
modifying the U-Boot configure parameters.
How to enter the u-boot command mode:
Power on the board and press any key on PC's keyboard to enter u-boot when you
see "Hit any key to stop autoboot" in your terminal window.
U-Boot SPL 2015.07-ga66ad5e-dirty (Jun 19 2017 - 14:48:34)
The Expected Linux image was not found. Please check your NAND configuration.
Trying to start u-boot now...
U-Boot 2015.07-ga66ad5e-dirty (Jun 19 2017 - 14:48:34 +0800)
Watchdog enabled
I2C: ready
DRAM: 512 MiB
NAND: 512 MiB
MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1
*** Warning - bad CRC, using default environment
Net: <ethaddr> not set. Validating first E-fuse MAC
cpsw, usb_ether
Hit any key to stop autoboot: 0
U-Boot# 0 (press any key to enter uboot)
1） Configuring for 4.3-inch LCD;
Execute the following instructions in u-boot mode to configure for 4.3-inch
display mode;

U-Boot# setenv dispmode 4.3inch_LCD
Copyright © 2017 Embest Technology SBC8600B-UM-V2.0
61