Usb Host Testing - Embest SBC8600B User Manual

Embest Technology Co., Ltd
5） Use ping command in HyperTerminal window to test if the network works
properly;

root@arm:~# ping 192.168.1.15
The information in HyperTerminal window is shown below;
PING 192.168.1.15 (192.168.1.15): 56 data bytes
64 bytes from 192.168.1.15: seq=0 ttl=128 time=0.885 ms
64 bytes from 192.168.1.15: seq=1 ttl=128 time=0.550 ms
The above information indicates the network has been created successfully.
Note:
Please ensure the IP addresses used above and the Ethernet IP address of the board are set
in different segments.

3.11.9 USB Host Testing

1） Insert a flash drive to the USB interface on SBC8600B, and then execute the
following instruction to view the flash drive's device name assigned by the
system;
root@arm:~# df –h

The information in HyperTerminal window is shown below;
Filesystem
......
/dev/sda1
The characters in bold in the above information is device name of the flash drive;
Continue to execute the following instruction to view the contents of the disk;

root@arm:~# ls /media/usbhd-sda1/
Copyright © 2017 Embest Technology
Testing Information
Table 1
Flash Drive Device Name
Size Used Available Use% Mounted on
3.7G 74M 3.6G 2% /media/usbhd-sda1
SBC8600B-UM-V2.0
71