Usb Device Testing - Embest SBC8600B User Manual

Embest Technology Co., Ltd
Contents of TF Card
MLO
logo.bmp

3.11.8 USB DEVICE Testing

The test of USB device is accomplished by creating a network communication
between miniUSB interface on the board and USB interface on PC;
1） After system boots up, connect SBC8600B to your PC with a Mini B-to-USB A
cable, and then you need to install Linux USB Ethernet driver; please refer to 错
误!未找到引用源。 错误!未找到引用源。.
2） Execute the following instructions to set IP address of the USB interface of
SBC8600B (the IP used below is only for reference; you can select a difference
IP);

root@arm:~# ifconfig usb0 192.168.1.115

root@arm:~# ifconfig
The information in HyperTerminal window is shown below;
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:26 errors:0 dropped:0 overruns:0 frame:0
TX packets:26 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2316 (2.2 KiB) TX bytes:2316 (2.2 KiB)
usb0 Link encap:Ethernet HWaddr 5E:C5:F6:D4:2B:91
inet addr:192.168.1.115 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:253 errors:0 dropped:0 overruns:0 frame:0
TX packets:43 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:35277 (34.4 KiB) TX bytes:10152 (9.9 KiB)
Copyright © 2017 Embest Technology
ramdisk.img uEnv.txt
u-boot.img
SBC8600B-UM-V2.0
69