Extract Bsp And Project Files To Ide; Sysgen & Bsp Compilation; Introduction Of Drivers - Embest SBC8600B User Manual

Embest Technology Co., Ltd

5.2.2 Extract BSP and project files to IDE

Please follow the steps listed below:
1) Uncompress [CD\WINCE700\BSP\SBC8600.rar] to [C:\WINCE700\PLATFORM]
2) Uncompress [CD\WINCE700\BSP\COMMON_TI_V1.rar] to
[C:\WINCE700\PLATFORM\COMMON\SRC\SOC]
3) Uncompress [CD\WINCE700\BSP\3rdParty.rar] to [C:\WINCE700]
4) Uncompress [CD\WINCE700\BSP\powerVR.rar] to [C:\WINCE700\public]
5) Copy [CD\WINCE700\project\SBC8600] to [C:\WINCE700\OSDesigns]
Note:
 The default installation directory of Windows Embedded Compact 7 is [C:\WINCE700]
hereafter.
5.2.3 Sysgen & BSP Compilation
Please follow the steps listed below to build Sysgen and BSP:
Open the existing project file SBC8600.sln under
[C:\WINCE700\OSDesigns\SBC8600]
Select [Build-> Build Solution] in VS2008 to start the process of sysgen and BSP
compilation.
Copy the files MLO, EBOOTSD.nb0 and NK.bin under
[C:\WINCE700\OSDesigns\SBC8600\SBC8600\RelDir\SBC8600_ARMV7_Rele
ase] to the TF card after compilation is done.
Insert TF card into SBC8600B and short the jumper JP5, and then power it on.

5.2.4 Introduction of Drivers

This table lists out all the drivers and the directories under which they are saved:
Copyright © 2017 Embest Technology
Table 5-4 Source Location
SBC8600B-UM-V2.0
113