Special Set-Up Procedure - Outer Column Repositioning - 3M -Matic 7000r Instructions And Parts List

13-MAINTENANCE - Special Set-Up Procedure - Column Re-Positioning (continued)
13.12 Special Set-Up Procedure for Outer Column Re-Positioning
Moving the outer columns will increase or decrease the
box height handled by the 7000r-7000r3 Pro case sealer.
Maximum Height:
An additional adjustment can be made to reach Maximum
Height. This additional height adjustment can be made by
moving the Upper Assembly Crossbar up to top holes -
(Figure 13-9).
Box Height Range – (Refer to Figure 13-8 / Section 7 /
and Specifications)
The operating range of the upper drive assembly can be
adjusted to minimize its movement (which increases the
operating speed) and in conjunction with adjusting the bed
height, to change the range of box heights being sealed.
After establishing the minimum box height to be sealed,
position the stop bumpers as follows:
1. Latch upper drive assembly in upper position, turn off
air and electric.
2. Remove and relocate the stop bumper assembly to
the desired position on both side columns. Be sure
that the stop bumpers are reassembled as shown and
secure (Figure 13-7 and Figure 15856).
3. Turn on the air and electrical power to the case sealer.
The upper taping head will now descend only part way
thus increasing operating speed.
• To reduce the risk associated with mechanical and electrical hazards:
− Turn electrical and air supply off and disconnect before performing any adjustments,
maintenance or servicing the machine or taping heads
• To reduce the risk associated with muscle strain:
− Use the appropriate rigging and material handling equipment when lifting or repositioning
this equipment
7000r-7000r3 Pro - NA
Figure 13-9
WARNING
WARNING
49
2014 June