Installation; Operating Conditions; Space Requirements For Machine Operation And Maintenance; Tool Kit Supplied With The Machine - 3M -Matic 7000r Instructions And Parts List

7-INSTALLATION

7.1 Operating Conditions

The machine should operate in a dry and relatively
clean environment (See Specifi cations).
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall (Figure 7-1):
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.
B
A

7.3 Tool Kit Supplied with the Machine

A tool kit containing some tools are supplied
with the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
Figure 7-2
7000r-7000r3 Pro - NA
Figure 7-1
21
WARNING
To reduce the risk associated with
•
muscle strain:
− Use the appropriate rigging and material
handling equipment when lifting or
repositioning this equipment.
− Use proper body mechanics when
removing or installing taping heads that are
moderately heavy or may be considered
awkward to lift.
7.4 Machine Set-Up / Bed Height
1 - Lift the machine with belts or ropes paying attention
to place the belts in the points (Figure 7-2).
To set the machine bed height, do the following:
2 - Adjust machine bed
height. The case
sealer is equipped
with four (4) adjust-
able legs that are
located at the cor-
ners of the machine
frame.
The legs can be
adjusted to obtain
different machine
bed heights
(Figure 7-3).
Also refer to the
"Specifi cations"
section.
3 - Lock the screws.
4 - Repeat the
operation for all legs.
(It is not necessary
to fi x or anchor the
machine to the fl oor).
5 - For Outer Column Repositioning -
See Special Set-up Procedure (Section 13).
Figure 7-3
2014 June