Applying Mechanism Spring; One-Way Tension Roller - 3M -Matic 7000r Instructions And Parts List

Adjustments (continued)
WARNING
• To reduce the risk associated with
shear, pinch, and entanglement hazards:
− Turn air and electrical supplies off on
associated equipment before performing
any adjustments, maintenance, or servicing
the machine or taping heads
− Never attempt to work on the taping head or
load tape while the box drive system is
running

Applying Mechanism Spring

To obtain access to the spring, remove the taping
head cover (four mounting screws). Replace cover
when fi nished.
The applying mechanism spring, shown in
Figures 5-4A and 5-4B, controls applying and
buffi ng roller pressure on the box and returns
the mechanism to the reset position. The spring
pressure is pre-set, as shown in Figure 5-4A for
normal operation, but is adjustable.
If a tape gap appears on the trailing surface of the
box increase spring pressure. If the front of the box
is being crushed by the applying roller decrease
spring pressure.
Removing the spring end loop from the spring holder
and placing loop in other holes provided, as shown
in Figure 5-4B, will adjust the spring pressure.

One-Way Tension Roller

Figure 5-5
The one-way tension roller is factory set. When
replacing this assembly, the roller must have a force
of approximately 0.5 kg to 0.9 kg [1 to 2 lbs.] when
turning.
To Adjust Tension:
1. Wrap a cord or small strap (non-adhesive) 4-6 turns
around the tension roller.
2. Attach a spring scale to the end of the cord or strap.
3. Turn the adjusting nut with the socket wrench
provided, until a force of approximately 0.5 kg to 0.9
kg [1 to 2 lbs.] is required to turn the roller by pulling
on the spring scale.
AccuGlide 3 - 3" - NA
A
Figure 5-4 Applying Mechanism Spring
Adjusting Nut
Figure 5-5 One-Way Tension Roller
15
B
0.5 - 0.9kg
[1 - 2 lbs.]
2013 April