3M -Matic 7000r Instructions And Parts List page 60

13-MAINTENANCE - Special Set-Up Procedure - Column Re-Positioning
• To reduce the risk associated with mechanical and electrical hazards:
− Turn electrical and air supply off and disconnect before performing any adjustments,
maintenance or servicing the machine or taping heads
13.12 Special Set-Up Procedure for Outer Column Re-Positioning (continued on next page)
Moving the outer columns will increase/decrease the maximum box height capacity of the 7000r-7000r3 case sealer.
1. On both sides, place a solid spacer block (as needed to support column and to help line up new holes) between
fl oor and bottom of outer column (Figure 13-8A).
2. On both front and rear, place solid spacer blocks (14" [355mm]) and lower the upper taping head assembly until
the upper assembly rests on blocks.
3. Remove eight (8) column screws (Figure 13-8B).
4. Place second spacer block under column (Figure 13-8A).
5. Re-attach/tighten the eight (8) screws and washers in each column (Figure 13-8B).
6. Remove existing guard and attach inner guide plate using hardware provided (Figure 13-8B).
Important! When the column is in the upper position, the Inner Column Guard must be installed (Figure 13-8B).
• To reduce the risk associated with muscle strain:
− Use the appropriate rigging and material handling equipment when lifting or repositioning this equipment
• To reduce the risk associated with impact hazards:
− Always use appropriate supporting means when working under the upper drive assembly
A
7000r-7000r3 Pro - NA
WARNING
WARNING
Upper
Assembly
Spacer(s)
Column Spacer (#2)
Column Spacer (#1)
B
48
Inner
Guard
replaces
existing
Guard
Note:
Remove
Column
Screws
Figure 13-8
2014 June