Table of Contents
Advertisement
2 Gas section
The walls adjacent to the cooker must be of material resistant to heat.
Gas connection
the connection must be executed by a qualified tecnician according to the
relevant standards.
The appliance is predisposed and calibrated to operate with the gas
indicated on the specifications plate.
Ensure that the room in which the cooker is to be installed is adequately
ventilated, in compliance with applicable regulations.
Connection to the gas supply pipe or gas cylinder must be made in
accordance with the requirements of the applicable regulations.
The gas supply is connected at the rear of the cooker (fig. 2.1) the
connection pipe must not cross the rear of the appliance.
Before installation, make sure that the local distribution conditions
(type of gas and its pressure) and the adjustment of this appliance
are compatible. The appliance adjustment conditions are given on the
plate or the label.
Gas inlet pipe
Connector
14
Fig. 2.1
Advertisement
Table of Contents
