Table of Contents
Advertisement
Warning! Not dishwasher safe.
If left on the surface for a length of time, acidic substances such as
lemon juice, tomato sauces and passata, vinegar and other similar
products will damage the surface and dull its shine.
After cleaning, the burners and their flame spreaders must be well
dried and correctly replaced.
It is very important to check that the burner flame spreader and the
cap have been correctly positioned. Failure to do so can cause serious
problems.
Check that the electrode "S" (figs. 6.1, 6.3) next to each burner is always
clean to ensure trouble-free sparking.
Check that the probe "T" (figs. 6.1, 6.3) next to each burner is always clean
to ensure correct operation of the safety valves.
Both the probe and ignition plug must be very carefully cleaned.
Note
The electrode "S" must be very carefully cleaned. To avoid damage to
the electric ignition do not use it when the burners are not in place.
Note
Continuous use may cause a change in the glaze around the burners
and grids, corresponding to the areas exposed to the heat. This is a
natural phenomenon and does not prevent the parts from working
properly.
Correct replacement of the auxiliary, semi-rapid and rapid burners
It is very important to check that the burner flame distributor "F" and the
cap "C" has been correctly positioned (see figs. 6.1 - 6.2) - failure to do so
can cause serious problems.
Correct position of the triple ring burner
The burner must be correctly positioned; failure to do so can cause
serious problems. Fit the flame spreader to the housing as shown by the
arrows (see fig. 6.3).
The burner correctly positioned must not rotate (fig. 6.4).
Then position the cap "A" and the ring "B" (figs. 6.4, 6.5).
57
Advertisement
Table of Contents
