Table of Contents
Advertisement
A) Gas connection
NL
Cat: II 2EK3B/P
The gases used for the operation of cooking appliances may be grouped
by their characteristics into two types:
* G25.3 Natural gas
* G20 Natural gas
* G30 / G31 Butane/Propane
The fitting (fig. 2.2) is made up of:
A - Gas train terminal fitting
B - Gasket
C - Conical connector
Use rigid or flexible connection pipes which comply with applicable regulations.
If compression fittings are used, tighten firmly using two spanners (fig. 2.4).
In particular, make sure that:
* the flexible hose does not come into contact with any parts of the cooker
with surface temperatures in excess of 70˚C;
* the flexible hose does not exceed 75 cm in length and does not come into
contact with sharp edges or corners;
* the hose is not under tension or twisted and is not kinked or too tightly bent;
* the connection with rigid metal pipes should not cause stresses to the gas ramp.
* we advise replacing the gasket on the slightest sign of deformation or
imperfection.
* the hose can easily be inspected along its entire length to check its
condition; hoses should replaced after a maximum of three years.
* the cylinder cock or the supply cock immediately ahead of the appliance
is closed whenever the cooker is not in use.
15
Advertisement
Table of Contents
