Graco 24Z764 Instructions Manual page 50

Modules
Installation Instructions
1. Tie wrap the 3-tube bundle and 2-tube #2 marked
bundle together as a group. These will follow the air
brake line over the wheel area.
NOTE: Skip Step 1 if there is not a 2-tube #2 tube
bundle required for your installation.
2. Use double-strap ties (Part No. 25C980) to attach
tube to air brake line. Strap should be snug but not
overtightened.
3. Anchor the first tie at frame fitting and the last tie of
this bundle at the fitting on brake can. This will
prevent strain on air hose.
4. Connect upper king pin first.
5. When routing lines to lower king pin and tie rod
connection, make sure there is clearance away from
the wheel.
6. The tie rod line (black) will be tied to lower king pin
fitting after the connection is made. Route the line
up and over tie rod arm to loop over rear of tie rod
end. This will reduce the chance of the line getting
snagged by road debris.
7. Run clutch lines under or through frame rail. Allow
enough slack in line for drive train movement. The
left cross shaft lube point may be easier to access
by removing floor panel around shift base.
8. Run spring hanger lube lines along side of frame
attaching every 12-15 inches. After attaching the
first line to the upper fitting, secure the other lube
line to that fitting. Then connect to the lower spring
hanger. This assures that the line will travel with the
hanger.
50
9. The lube line for the spring pin is black and single.
Route the line so it will be supported every 12-15
inches of travel.
10. The inlet for the module is through the stud. Use an
elbow, Part No. 556639 or tee, Part No. 556636,
depending on the routing of the main line. Alternate
ports are on each end of the module.
11. Optional: Ports 3 or 4 on the module are used for
additional lube points. i.e., rear spring, assisted
steering, throw out bearing.
3A5082G