Graco 24Z764 Instructions Manual page 48

Modules
Installation Instructions
1. Tie wrap the 3-tube bundle, 2-tube bundle and
(2-tube #2, if present) marked bundle together as a
group. These will follow the air brake line over the
wheel area.
2. Use double-strap ties (Part No. 25C980) to attach
tube to air brake line. Strap should be snug but not
overtightened.
3. Anchor the first tie at frame fitting and the last tie of
this bundle at the fitting on brake can. This will
prevent strain on air hose.
4. Connect upper king pin first.
5. When routing lines to lower king pin and tie rod
connection, make sure there is clearance away from
the wheel.
6. Tie the tie rod line (black) to lower king pin fitting
after the connection is made. Route the line up and
over tie rod arm to loop over rear of tie rod end. This
will reduce the chance of the line getting snagged
by road debris.
7. Run spring hanger lube lines along side of frame
attaching every 12-15 inches. After attaching first
line to the upper fitting, secure the other lube line to
that fitting then connect into the lower spring hanger.
This assures that the lube line will travel with the
hanger.
8. Route the lube line for the spring pin (black, single)
so that it will be supported every 12-15 inches of
travel.
9. The inlet for the module is through the stud. Use an
elbow, Part No. 129755 or tee, Part No. 129759,
48
depending on the routing of the main line. Alternate
ports are on each end of the module.
10. Optional: Ports 7 & 8 on the modules are used for
additional lube points. i.e., rear spring or clutch
linkage.
F . 42: *Tee 129759 shown. Can also use
IG
elbow 129755
*
3A5082G