Graco 24Z764 Instructions Manual page 23

Enter the Time:
• The time displays in 24-Hour format. i.e., 2:45 PM
displays as 14:45.
• The clock is set in Hours and Minutes (HH:MM).
• The LED under the
HH lights when
setting hours and the
LED under the MM
lights when setting
minutes.
• The first programmable number of the HH (hour)
filed blinks, indicating the device is ready to program
the first digit of the hour.
• When programming a time of less then 12 hours,
you must program a leading zero in the first number
field and press the ENTER button to save the zero.
1. Use the UP and DOWN ARROW
buttons to move up and down
through the numbers 0-2 until the
desired number appears in the first
hour (HH) field.
2. Press the ENTER button to set the
number.
3. Use the UP and DOWN ARROW buttons to move
up and down through the numbers 0-9 until the
desired number for the second HH number field
appears.
4. Press the ENTER button to set the
number.
3A5082G
or
5. The next number field to the right blinks and the
LED under the MM lights indicating the is ready to
program the minutes fields.
6. Repeat steps 1-4 to set the minutes (MM) fields.
7. After pressing the ENTER button to
set the time, the programmed Time
information is saved.
ON Time
• The LED next to the clock in the ON
field lights, indicating you are setting
the ON Time parameters.
• ON Time is set in Minutes and Seconds (MM: SS).
• An LED flashes under
either MM when
programming minutes
OR SS when
programming
seconds.
• In SETUP MODE, the
number displayed in
the first field, on the
left side of display
blinks, indicating the
device is ready to
program the ON Time minutes.
• The total amount of ON Time cannot
be 0 or exceed 30 minutes. If a value
of 0 or a value greater than 30 minutes
is entered, the RED alarm LED lights
and the value must be updated.
Pump
OR
23