Table of Contents
Advertisement
Quick Links
Instructions
Box Lubricator /
Lubricator Reservoir
Lubrication reservoir used with GBL 7500 Gravity Fed or Pressure Fed Box Lubricator Pumps for
dispensing non-corrosive and non-abrasive oils and lubricants. For professional use only.
Maximum Input: 1800 RPM
Drive Ratio: 118:1
Models, page 3.
Important Safety Instructions
Read all warnings and instructions in this
manual before using the equipment. Save
these instructions.
Related Manuals
Manual
(English)
Description
3A2257
GBL 7500 Box Lubricator Pump and GBL Shaft
Rotation/Low Level Alarm Pump
3A3006F
EN
Advertisement
Table of Contents
Related Manuals for Graco 24W633
Summary of Contents for Graco 24W633
- Page 1 Instructions Box Lubricator / Lubricator Reservoir 3A3006F Lubrication reservoir used with GBL 7500 Gravity Fed or Pressure Fed Box Lubricator Pumps for dispensing non-corrosive and non-abrasive oils and lubricants. For professional use only. Maximum Input: 1800 RPM Drive Ratio: 118:1 Models, page 3.
-
Page 2: Table Of Contents
California Proposition 65 ....17 Graco Standard Warranty ....18... -
Page 3: Models
Models Maximum Pump Model Description Working Certification Quantity Pressure (psi) 24W633 Reservoir Assembly, 4 Pint, RH 25R513 Reservoir Assembly, 4 Pint, LH 24W634 Reservoir Assembly, 6 Pint, RH 25R514 Reservoir Assembly, 6 Pint, LH 25R555* Box Lubricator, 4 Pint, 3/8 in. pump, RH... -
Page 4: Warnings
Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable. - Page 5 Warnings WARNING EQUIPMENT MISUSE HAZARD Misuse can cause death or serious injury. • Do not operate the unit when fatigued or under the influence of drugs or alcohol. • Do not exceed the maximum working pressure or temperature rating of the lowest rated system component.
-
Page 6: Component Identification
Component Identification . 1: Key: Sight Glass Drain Plug Fill Cover Pump Mounting Screws The GBL 7500 Box Lubricator Pump and GBL Alarm Pump are available from Graco. See Accessories, page 13 for information about the pump models. 3A3006F... -
Page 7: Installation
Securely mount and ground the lubricator before operation. • Refer to the pump instruction manual for installation and priming instructions. See Parts, page 12 for Graco pump model information. Installation Procedure The uppercase letters used in the following instructions Drive Mechanism refer to Component Identification (F . -
Page 8: Operation
Operation Operation Break In Period The letters used in the following instructions refer to Component Identification (F . 1), page 6. Fill the gear box to the FULL line on the Sight Glass (A) with SAE 30 to SAE 40 weight gear lube. Run normally, Pressure Relief Procedure and change the gear lube after the two week break in period (F... -
Page 9: Maintenance
Maintenance Maintenance Lube Refill/Replace When needed, refill the reservoir with clean filtered lubricant until it reaches the FULL line on the Sight Moving parts can pinch, cut or amputate fingers and Glass (A) (F . 3). other body parts. Follow the Pressure Relief Procedure from your pump manual, before performing maintenance of the pump. -
Page 10: Recycling And Disposal
Recycling and Disposal Recycling and Disposal End of Product Life At the end of the product’s useful life, dismantle and recycle it in a responsible manner. • Perform the Pressure Relief Procedure. • Drain and dispose of fluids according to applicable regulations. -
Page 11: Troubleshooting
Troubleshooting Troubleshooting 1. Follow the Pressure Relief Procedure in your pump manual before checking or repairing the lubricator. 2. Check all possible problems and causes before disassembling. Problem Cause Solution The lube level is not visible in the Low oil level in reservoir. Add oil. -
Page 12: Parts
SCREW, machine, hex washer 132656 RESERVOIR, 6 pt, models head, models 24W634 and 25R514, 25R556, and 25R558 24W635 16Y559 COVER, models 24W633 and 557391 PLUG, dry seal, 1/4 NPTF 24W636 34 16G243 LABEL, safety, warning, injection, 17D148 COVER, models 24W634 and... -
Page 13: Accessories
Accessories Accessories Pumps* Part No. Description 24J391 3/16 in. Suction Fed Pump 24J392 1/4 in. Suction Fed Pump 24J393 3/8 in. Suction Fed Pump 24J394 3/16 in. Gravity Fed Pump 24J395 1/4 in. Gravity Fed Pump 24J396 3/8 in. Gravity Fed Pump 24J397 3/16 in. -
Page 14: Technical Specifications
1/4 in. 6000 psi 41.4 MPa, 414 bar 3/8 in. 3500 psi 24.1 MPa, 241 bar Reservoir Capacity Models 24W633, 24W636, 25R513, 25R555, 4 Pints 25R557, 25R559 Models 24W634, 24W635, 25R514, 25R554, 6 Pints 25R556, 25R558 Temperature Operating Temperature Range, Non-ATEX -20°F to 140°F... -
Page 15: Reservoir And Mounting Dimensions
Reservoir and Mounting Dimensions Reservoir and Mounting Dimensions Dimensions are shown in inches (mm) - See Dimensions Table, page 16 3A3006F... -
Page 16: Dimensions Table
Reservoir and Mounting Dimensions Dimensions Table Part No. Description inch inch inch inch inch Lubricator Reservoir 24W633 4 Pint 25R513 24W636 14.25 361.95 7.24 183.90 139.7 1.74 44.20 Box Lubricator 25R555 9.67 245.62 4 Pint 25R557 25R559 Lubricator Reservoir 24W634... -
Page 17: California Proposition 65
Reservoir and Mounting Dimensions California Proposition 65 CALIFORNIA RESIDENTS WARNING: Cancer and reproductive harm – www.P65warnings.ca.gov. 3A3006F... -
Page 18: Graco Standard Warranty
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.