Graco 24Z764 Instructions Manual page 27

Sample System Event Log
Example Event Log: The pump cycle of a typical
lubrication system is shown below.
System Event Log
DMS ID Number: 00613
Software Part No.: 17J936
Software Version: 0703
09/29/2016 14:1400
Date Time Description
9/29/2016 14:13:02 Pump Run Off
9/29/2016 14:13:02 Program Variable Change
9/29/2016 14:12:39 Pump Run On
9/29/2016 14:12:34 Local Manual Run Initiated
Common System Events are listed below.
Pump Run On The pump entered an on cycle and is
operating and dispensing material.
Pump Run Off The pump entered an off cycle and is
not dispensing.
Pump Run A pump on cycle was canceled by
Canceled pressing the cancel button on the front
panel and holding it for 3 seconds.
Program Variable The setup mode was entered.
Change
Local Manual Run The manual run button was pressed,
Initiated initiating a pump on cycle.
Remote Manual The remote manual run button was
Run Initiated pressed initiating a pump on cycle.
Successful Pin The pin code was successfully entered
Code Entry and the user has entered setup mode.
Cold Delay The pump entered a cold delay
Firmware Update The firmware was updated successfully.
Completed
3A5082G
Pump
27