Connecting The Printer To The Network; Connecting To A Computer Using Usb; Connecting To A Telephone Line - Xerox WorkCentre 3335 User Manual

C C o o n n n n e e c c t t i i n n g g t t h h e e P P r r i i n n t t e e r r t t o o t t h h e e N N e e t t w w o o r r k k
Use a Category 5 or higher Ethernet cable to connect the printer to the network. An Ethernet network
is used for one or more computers and supports many printers and systems simultaneously. An
Ethernet connection provides direct access to printer settings using Xerox
Services.
To connect the printer:
1. Ensure that the printer is powered off.
2. Connect one end of a Category 5 or higher Ethernet cable to the Ethernet port on the printer.
Connect the other end of the Ethernet cable to a correctly configured network port on a hub or
router.
3. Connect the power cord to the printer, and plug the cord into an electrical outlet.
4. Turn on the printer.
For details on configuring network settings, refer to the System Administrator Guide at:
• www.xerox.com/office/WC3335docs
• www.xerox.com/office/WC3345docs
5. Enter the printer IP address or set Xerox
discover the network IP address of the printer.
C C o o n n n n e e c c t t i i n n g g t t o o a a C C o o m m p p u u t t e e r r U U s s i i n n g g U U S S B B
To connect using USB, you need Windows 7, Windows 8 or later, Windows Server 2008 or later, or
Macintosh OS X version 10.9 or later.
To connect the printer to the computer using a USB cable:
1. Connect the B end of a standard A/B USB 2.0 cable to the USB Port on the front, right side of the
printer.
2. Connect the A end of the USB cable to the USB port on the computer.
3. If the Windows Found New Hardware Wizard appears, select Cancel.
4. Install the print drivers. For details, refer to
C C o o n n n n e e c c t t i i n n g g t t o o a a T T e e l l e e p p h h o o n n e e L L i i n n e e
Note: Not all options listed are supported on all printers. Some options apply only to a specific
printer model, configuration, operating system, or driver type.
1. Connect a standard RJ11 cable, No. 26 American Wire Gauge (AWG) or larger, to the Line port on
the back of the printer.
2. Connect the other end of the RJ11 cable to an operating telephone line.
3. Enable and configure the Fax functions.
For details, refer to the System Administrator Guide at:
• www.xerox.com/office/WC3335docs
• www.xerox.com/office/WC3345docs
® CentreWare ® Internet Services to automatically
Installing the Software.
Xerox ® WorkCentre ® 3335/3345 Multifunction Printer
Installation and Setup
® CentreWare ® Internet
User Guide
39