Connecting A Vcr; Connecting One Vcr - PictureTel Concorde 4500 Servicing Manual

Connecting One
VCR
This appendix shows you how to connect one or two VCRs to the
Concorde¥4500.
You can connect one or two VCRs to the Concorde¥4500 for
recording and playing a videotape. If you connect one VCR, motion
video can be sent from the VCR to the far-end videoconferencing
system, or the videoconference can be recorded. Connecting two
VCRs allows video to be sent from one VCR while the other VCR
records the videoconference.
The following instructions can be used for connecting a mono or
stereo VCR. If you are connecting a stereo VCR, make sure that you
plug the cables into the same side of the Line In and Line Out
connectors, either the left or the right side. Refer to the section
ÒConnecting a Stereo VCR.Ó
To connect one VCR to the Concord¥4500:
1. Power down the videoconferencing system.
2. Plug one of the RCA-to-RCA cables (that come with the VCR) from
the VIDEO IN connector on the VCR to the VCR OUT
connector on the Concorde•4500 Video board.
3. Plug the other RCA-to-RCA cable from the VIDEO OUT connector
on the VCR to the VCR IN
Video board.
This document was created with FrameMaker 4.0.4

Connecting a VCR

connector on the Concorde•4500
E
E-1