Pin Assignments; Table B-1: Pin Assignments For The Powercam 8-Pin Connector - PictureTel Concorde 4500 Servicing Manual

PowerCam 100
Cable
This appendix lists the pin assignments for various components that
make up the Concorde¥4500.
A single cable connects from the Y/C video output on the back of
the PowerCam 100, to the video input connector on the video board.
The cable carries power, bidirectional data, and S-VHS video.
The following table lists the pin assignments for the 8-pin DIN
camera control interface connector.
Note: If you are using an older model PictureTel PTZ camera,
which has an 8-pin and a 4-pin connector, you will need
to purchase a Y adapter cable (part # 180-0189-01) to
connect the camera to the video input connector on the
video board.
Table B-1: Pin Assignments for the PowerCam 8-Pin
Connector
Pin
1
2
3
This document was created with FrameMaker 4.0.4

Pin Assignments

Description
Electronics module to camera module data TX,
EIA RS-423A or RS-232C compatible input
Camera module to electronics module data RX,
EIA RS-423A or RS-232C compatible output
Ground (digital data)
B
B-1