7
Problem Solutions and Tips
V
CAUTION!
Observe the safety information in the manual "Safety, Warranty and
Ergonomics" and the chapter "Installation" on page 17 and "System
Components and Expansions" on page 71 when connecting or discon-
necting cables.
If a fault occurs, try to correct it as described:
– in this chapter
– in the documentation of the connected devices
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a note of the steps and the circumstances that led to the fault. Note
also any error message which may have been displayed.
Ê Switch the server OFF.
Ê Contact our Service organization.
7.1
Power-on Indicator Remains Dark
The power-on indicator remains dark after switching on.
Power Cable Incorrectly Connected
Ê Make sure that the power cable is correctly connected to the server and to
the grounded power socket.
Power Supply Overloaded
Ê Unplug the server power plug out of the power socket.
Ê Wait a few seconds and plug the power plug into the power socket again.
Ê Switch your server ON.
U41271-J-Z156-2-76
63