Table of Contents
Advertisement
Installation
3.3
Setting Up the Floorstand Model
Ê Position the server at the intended location.
Note the following:
– The device must be protected against direct sunlight.
– The required minimum distances for operation and maintenance areas must
be adhered to.
– The server must be accessible from the rear to connect external devices.
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and behind the
system to ensure adequate ventilation.
Figure 2: Remove the anti-tilt bracket from the floorstand model.
Ê Loosen the screw from the anti-tilt bracket and remove it (1), in order to be
able to move the server. Loosen the knurled screw (a).
I
Note that the stability of the server is reduced if the anti-tilt bracket is
removed.
U41271-J-Z156-2-76
Setting Up the Floorstand Model
a
19
Advertisement
Table of Contents
