Table of Contents
Advertisement
7
Problem Solutions and Tips
V
CAUTION!
Observe the safety information in the manuals "Security" and in chapter
"Hardware Installation" on page 27.
If a problem occurs, try to resolve it as described:
– in this chapter,
– in the documentation for the attached devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a note of the steps and the circumstances that led to the fault. Note
also any error message which may have been displayed.
Ê Switch the server OFF.
Ê Contact our Service organization.
7.1
Power-on Indicator Remains Dark
The power-on indicator remains dark after switching ON:
Power cable not connected correctly
Ê Make sure that the power cables are correctly connected to the server and
to the grounded power sockets.
Power supply overloaded
Ê Pull the server power plugs out of their sockets.
Ê Wait a few seconds and plug the power plugs into their grounded sockets
again.
Ê Switch your server ON.
A3C40069794
65
Advertisement
Table of Contents
